Worked like a champ. Thanks
fishspike
Posts: 194
Okay have everything mounted. The dongle cable hooks up to the unit but it’s too big for the transducer cable. Anyone know the right part number?
So does this connector go to the front fish finder. I’m not sure my Helix seven is networkable. So in that case will just use it up front as down image. Will attach some pics. The back story is I bought this boat in the fall and first time on water is coming.
Thanks Blank I have the map cards so I’m good there. I was getting confused (easily done) on networking them together.
Thanks again
If you expand the first pic you can see the connection of the 9. Ethernet switch is a must. Thanks
The nine does have i-Pilot. The 7 is networkable. Thanks folks
Sorry to ask basic questions.
Thinking this didn’t go well. Wouldn’t let me enter and I did everything they said.
Thanks for the great responses. Will be moving/replacing it
Thanks again
Hey do any of you Rebel owners have one of these plugs for your bank charger? And if so where on your boat?
Thank in advance
Thanks. Will look at it in the spring. Is there a propeller shop in east metro?
I agree with Dutchboy. Dropped my crest line the same way. Oblong the drain plug. Ran it for quite awhile. No issues
Thanks. May be a winter project Will check for power though on timer
Sorry. Still does not work. But I have a led light in switch that is on all the time now
Well I did this. Took all the cards out of booth units. Found LOW using the unit map. Took one card at a time to see what features popped up. After going through six cards I think I have them back in the right Big HD card. Not sure of the version though. It gets confusing because the MN card has some LOW on it. Just trying to stay out of Canada 👍. But here is a thought. The gentleman that does the You Tube Videos for hummingbird. Throw a bunch of unmarked micro cards in a pile and see how long before he lets out a cuss word. Seriously thanks for everyone suggestions it did help
Thanks thought Of doing that and you confirmed it. I have put the map source on auto and there is nothing on the screen. Go to contour and had and the lake shows up. Confusing
Right I have 9s front and back so need two cards. I fish Mn Wi and LOW. Cards are mixed and cannot figure how to get right cards where as fishing LOW this week end and what a mess
I have two ceiling fans in 36×48 shed. I also added a oscillating wall fan. And yes fans and fishing rods don’t get along🤬
Thanks. I feel bad I hijaced this thread. I should of started another. Here is what I did and will find out tomorrow if fixed
Went to factory defaults and reset again(3rd)
Went to website and downloaded latest software update
Installed update and the unit appears to being acting normal
Will test tomorrow and update you all
Thanks again for advice and sorry about the hijack