jack plate

  • clawman
    Spokane Wa
    Posts: 118
    January 18, 2014 at 5:05 pm #1360756

    Looking for more speed. Anyone running a jack plate on your MX 1825?

    woodenfish
    st.croix valley
    Posts: 62
    January 18, 2014 at 5:45 pm #1380805

    I have a detwiler hydraulic jack plate on my 202 triton tiller it has a dial so you can fine tune the sweet spot while running. Its sweet.

    splitshot
    Rosemount, MN
    Posts: 544
    January 18, 2014 at 9:06 pm #1380824

    Check your Skeeter warranty before you install. Installation of a jack plate used to void hull/transom warranty. It may be different now. …Check first though.

    francisco4
    Holmen, WI
    Posts: 3605
    January 19, 2014 at 8:31 am #1380853

    Quote:

    Looking for more speed. Anyone running a jack plate on your MX 1825?

    Dean ran a jack plate on his first 1825 with 200hpdi. Give him a shout at SBC.

    FDR

    Eric Rehberg
    Eau Claire, WI
    Posts: 3071
    January 19, 2014 at 3:16 pm #1380930

    I personally wouldn’t add one just to increase speed. You will be looking at about 2mph in speed. Main reason we ran one was for shallow water. Also just to try it. If you do add one, don’t get a cheap one

    Dean Marshall
    Chippewa Falls WI /Ramsey MN
    Posts: 5852
    January 19, 2014 at 3:54 pm #1380939

    Quote:

    I personally wouldn’t add one just to increase speed. You will be looking at about 2mph in speed. Main reason we ran one was for shallow water. Also just to try it. If you do add one, don’t get a cheap one

    x 2 Plus there is Some benefit FOR Rough water ride applications as well. Which motor & prop do you have and What is Your present performance?

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.