I think I’m going to pick up a new strikemaster 40v. I’m currently running the Honda 4 stroke with a 8″ bit. I was thinking about getting the 10″ bit on the new 40v. Are they the same attachment so I can run the 8″ and 10″ on both augers?
IDO » Forums » Fishing Forums » Ice Fishing Forum » Strikemaster 40v auger bit
Strikemaster 40v auger bit
-
January 4, 2019 at 9:30 am #1823046
Same. A buddy did that. Personally, I’d put the 8″ on the electric and the 10″ on the gas. Or just sell the gas auger with the 8″ bit (more demand) and get a 8″ electric. You’re likely never going to use the Honda again unless there’s 36″ of ice.
January 4, 2019 at 11:01 am #1823082That was my plan to put the 10″ on the Honda for in my permanent shack.
January 4, 2019 at 11:08 am #1823086That was my plan to put the 10″ on the Honda for in my permanent shack.
Just curious, why would you want to use a gas auger in the shack if you had an electric to use? Wouldn’t the lack of fumes be desirable?
jaybird1Posts: 31January 4, 2019 at 1:12 pm #1823115Yes they are the same. Here is the good news, using the 40V platform the 8″ and 10″ cutting speed/performance is almost exactly the same. Keep your 8″ and get the new 40V with a 10″ then your covered.
You must be logged in to reply to this topic.