Is it possible to have a livescope signal from one transducer show up on two 93 echomap plus sv’s? If so what is the best way to achieve this setup? Networking cable? Hub? Any input would be greatly appreciated. Thank you.
JT
Posts: 16
IDO » Forums » Fishing Forums » Toys for Big Boys » Garmin Electronics » Garmin Graph Setup
Is it possible to have a livescope signal from one transducer show up on two 93 echomap plus sv’s? If so what is the best way to achieve this setup? Networking cable? Hub? Any input would be greatly appreciated. Thank you.
if the 93 echomap plus have ethernet ports it should transfer everything between units. It works between GPSMAP xsv units
I believe you would need a port expander module. Pretty sure the 93sv only has 1 ethernet port that 1 unit will have used to connect to the gls 10. I am also looking into adding 2nd unit.
You can buy the Garmin network hub and networking cables to do it.
You can also buy a really cheap (but non waterproof) network switch ($10) as the hub too. I used some Ethernet cable I had around the house and networked two echomaps this way. You’ll need something to go from 12v to 5v for a switch like this. I also bought some Garmin Ethernet cable ends for $13 to waterproof the graph side connection.
You must be logged in to reply to this topic.