Probably a long shot but does anyone have or know where a good place to look for a windshield for a 2008 crestliner fish hawk would be? It’s the 1600 with the single bubble side steer. A friend broke his and can’t find a replacement anywhere.
Probably a long shot but does anyone have or know where a good place to look for a windshield for a 2008 crestliner fish hawk would be? It’s the 1600 with the single bubble side steer. A friend broke his and can’t find a replacement anywhere.
Make one out of tinted plexiglass. They are plexiglass to start with and pretty easy to heat and bend. Just did the same to my fishhawk because my driver side was cracked from some one over tightening the wrong hardware in it.
good luck. I looked for one for my 2002 1850 fishhawk for a long time. I finally gave up.
good luck. I looked for one for my 2002 1850 fishhawk for a long time. I finally gave up.
Did you make one ? Took me less then 45 minutes to heat and bend my windshield and have it done. Can even cut it to the height you want because the stock height is to short and puts the rain right in your face. Cost me 50 bucks if I remember right.
Ill do it for him for 500
<div class=”d4p-bbt-quote-title”>fishthumper wrote:</div>
good luck. I looked for one for my 2002 1850 fishhawk for a long time. I finally gave up.Did you make one ? Took me less then 45 minutes to heat and bend my windshield and have it done. Can even cut it to the height you want because the stock height is to short and puts the rain right in your face. Cost me 50 bucks if I remember right.
Ill do it for him for 500
Mine was the second windshield on the passenger side. I actually like it better without it.
He can try calling the mfg directly but those windshields are nearly impossible to find. If you can make one like BC mentioned that would be the way to go.
I busted a full windshield in a 2006 Lund and we had to have the mfg get the original mold out and recast it.
Tanks guys. I figured it was a way long shot. I never knew plexiglass was so easy to work with. I’ll tell him to check it out
Tanks guys. I figured it was a way long shot. I never knew plexiglass was so easy to work with. I’ll tell him to check it out
.
Use a weed burner and keep a distance so you dont melt nor burn. Bend it to fit and then etch your cuts
Worse case senerio he can always try these guys.
You must be logged in to reply to this topic.
