Lowrance gen 1 and gen 2

  • walleyeguy000
    Rochester, MN
    Posts: 204
    February 18, 2017 at 8:36 am #1675013

    I was wondering if you can link a Hds gen 1 and Hds gen 2 together thru a lss1 structure scan unit like you can with two gen 1 Hds units and they will work together with gps marks/sonars settings etc?

    CaptainMusky
    Posts: 19171
    February 18, 2017 at 8:43 am #1675016

    Yes it should work just fine. I like to use the Ethernet between two units for the waypoint sharing. Save a waypoint on one unit and it instantly pops up in the other.

    bullcans
    Northfield MN
    Posts: 1937
    February 18, 2017 at 10:39 am #1675032
    CaptainMusky wrote:

    Yes it should work just fine. I like to use the Ethernet between two units for the waypoint sharing. Save a waypoint on one unit and it instantly pops up in the other.

    x2
    I do the same and have a gen 1 linked to a gen 2 through the lss1 module

    walleyeguy000
    Rochester, MN
    Posts: 204
    February 18, 2017 at 12:14 pm #1675040

    Thanks guys. I thought I could. Just wanna make sure

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.