Humminbrid 899 use w/o transducer

  • Chuck Melcher
    SE Wisconsin, Racine County
    Posts: 1964
    January 16, 2021 at 4:53 pm #2006588

    I have a cable and can power my unit up… but can’t get it out of simulation mode without a transducer. Want to use it on the ATV for mapping – is there a way around having a transducer hooked up? I played with it – and looked around on line.

    munchy
    NULL
    Posts: 4664
    January 16, 2021 at 5:30 pm #2006598

    I believe you have to turn off Sonar in one of the setup screens. Don’t have one handy to test unfortunately.

    gixxer01
    Avon, MN
    Posts: 639
    January 16, 2021 at 5:46 pm #2006599
    munchy wrote:

    I believe you have to turn off Sonar in one of the setup screens. Don’t have one handy to test unfortunately.

    Same screen where you adjust the brightness. Push the power button.

    munchy
    NULL
    Posts: 4664
    January 16, 2021 at 6:02 pm #2006601

    You can also try the startup screens where you press exit. A more permanent solution may be in there. Been a while since I played with mine.

    mxskeeter
    SW Wisconsin
    Posts: 3578
    January 16, 2021 at 6:58 pm #2006615

    I think you can turn off the views you don’t want to see.

    Chuck Melcher
    SE Wisconsin, Racine County
    Posts: 1964
    January 17, 2021 at 8:02 pm #2006926

    Thanks all! Got the sonar off, and changed out of simulation mode…. working perfectly on the ate now.

    Bill Perrotti
    Posts: 1
    March 8, 2021 at 9:09 pm #2020640

    Are you able to use the Lakemaster map without the transducer?

    deertracker
    Posts: 8959
    March 8, 2021 at 9:31 pm #2020645
    Bill Perrotti wrote:

    Are you able to use the Lakemaster map without the transducer?

    Yes, you can use mapping with the transducer off.
    DT

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.